![]() ![]() Now, Downloading ĭownloaded file at 0x30000000, size = 238232 bytesĮrasing Nand.nand_erase: attempt to erase a bad block at page 0x00000260 You'll see something like this as output, ignore the error message: Use the "s3c2410_boot_usb" utility ( ) to upload the "u-boot.bin" via usb: Press 'q' to go to the shell and do the "load flash" on address 0 with the size of "u-boot.bin" (238232 bytes in this example): You'll get the vivi output on the serial console. Power the board off, set the NOR switch to on, power the board on. We use the installed vivi bootloader to load uboot via usb. If you get an error about a missing whatever-gcc, verifiy if there is a hardcoded CROSS_COMPILE setting in the Makefile Git clone git://repo.or.cz/u-boot-openmoko/mini2440.gitĮxport CROSS_COMPILE=arm-none-linux-gnueabi-Įxport PS1="\\u \\w:\$: \" Setting up the bootloader Compiling uboot If you have a toolchain with another prefix (like arm-linux-) adapt the CROSS_COMPILE environment variable in the next steps. I used this one: Add the bin dir to the $PATH. ![]() Ethernet 10/100M Ethernet, RJ-45 connector.DISCLAIMER: This worked for me, if it eats your cat or burns your kitchen sink, don't blame me. Big thanks to BusError for the instructions and guidance. This is a howto install uboot and a new kernel on the mini2440. 6.3 Messed Up Screen Positions( or TS calibration) IN QT.6.2 Python Alignment trap, Segmentation fault.5 Bit Baking Angstrom, and QT Embedded 4. ![]()
0 Comments
Leave a Reply. |